Solana: Inconsistency between Program Id and anchor definitions
Name:
Solana: Program ID and anchor definition inconsistency – a guide to solve the problem
Introduction
Solana Blockchain intellectual solidarity contracts, one common challenge in an attempt to test its anchor definition. The ID of Smart Contract Program is often incompatible with its anchor definition, causing problems during the test. In this article, we will investigate why this happens and make recommendations on how to resolve inconsistency.
Why do program ID and anchor definition inconsistency
The function of the Solidity program is defined by using the “function function” keyword, followed by the return type, parameter list and block statements (if any). The ID of the Smart Agreement program is determined by its Genesis configuration. When creating anchor for testing purposes, the developer usually determines the program ID to meet the expected value.
However, during installation, the actual program ID may not match an anchor definition for a variety of reasons such as:
* Genesis Config Update : If Genesis Config is updated after the contract can change the program ID.
* Manual installation : The developer can accidentally or intentionally update the program ID manually.
* Invalid circuit code : Code code problems can cause discrepancies between the intended and actual program ID.
inconsistent program ID test
Testing the Solana anchor using the ContractDDRESS parameter, which is different from the expected value Genesis Config, causes inconsistent program ID. This inconsistency will result in the performance of the function of the contract.
Consistent Solution
To solve the inconsistency of the program ID and anchor definition:
1
2.
- Re -test : After making changes, repeat the test set to ensure consistency.
Conclusion
The program ID and anchor definition inconsistencies can cause problems during the test. However, with some simple actions, you can resolve these discrepancies and successfully test your Solana anchors. Remember to check the Genesis Config and use the ContractDress parameter properly to ensure accuracy in your tests.
additional sources
- [Documentation of Solana Creator] (
- [Solana Testing Guide] (